Click on an image to display a larger view.
 |
 |
| Interior of boxcar 3244 during its rebuild. |
|
|
 |
|
| Druby Hebert, Ron Lira and Alan Robson drill holes for hangin the steps on caboose 05635. |
|
|
|
 |
|
| Bob Reib and Jim McGee remove chinking on the Chama log bunkhouse. |
|
|
 |
|
| Warren Ringer rough cuts a notch in a pallet shelf with a circular saw. |
|
|
|
 |
|
| John Engs and Warren Ringer set up lumber storage racks inside storage reefer FHIX 40037. |
|
|
 |
|
| The rear (west) wall of the Chama log bunkhouse with the logs removed. |
|
|
|
 |
|
| Removing the flooring inside boxcar coach 3244, which will be converted back to a boxcar. |
|
|
 |
|
| Looking east at loaded lumber racks in the Antonito storage reefers. |
|
|
|
 |
|
| Ed Lowrance loads a pallet shelf with a pallet of journal box castings. |
|
|
 |
|
| The dust collector being installed at the Antonito CRF is partially completed and tied down, and the motor covered for protection from the weather. |
|
|
|
 |
|
| Interior of boxcar coach 3244, being rebuilt back to a boxcar. |
|
|
 |
|
| Interior framework of caboose 05635. |
|
|
|
 |
|
| Ron Lira and Alan Robson install windows on caboose 05635. |
|
|
 |
|
| Warren Ringer and John Cole begin construction of the shed that will store the Antonito CRF dust collector and compressor. |
|
|
|
 |
|
| The roof ledger board on the Antonito CRF and wall framing for the compressor area. |
|
|
 |
|
| Tim Bristow and Druby Hebert trim the ends of support beams for boxcar 3244. |
|
|
|
 |
|
| Jim McGee tests a new log insert for fit on the Chama log bunkhouse. |
|
|
 |
|
| Steve Fowler and Bill Strathern install the door for Chama depot telegraph booth. |
|
|
|
 |
|
| Wall framing for the dust collector/compressor addition to the Antonito CRF. |
|
|
 |
|
| Marshall Smith nails the end of a rafter for the dust collector/compressor addition to the Antonito CRF. |
|
|
|
 |
|
| Installation of fascia board on caboose 05635. |
|
|
 |
|
| Newly constructed telegraph booth in the Chama depot. |
|
|
|
 |
|
| Marshall Smith installs bridging between the studs on the Antonito CRF dust collector/compressor addition. |
|
|
 |
|
| Marshall Smith works on the Antonito CRF dust collector/compressor addition. |
|
|
|
 |
|
| Marshall Smith (on ladder) and John Cole (on roof) work on the Antonito CRF dust collector/compressor addition. |
|
|
|
